77
LATCH/UAS (Rear-Facing and Forward-Facing)
Installing LATCH/UAS
6. Attach LATCH/UAS Connectors
to vehicle Lower Anchor Bars.
Connectors will make an audible
CLICK when attached. Make sure
they are attached by pulling rmly
on connectors. If equipped with
Mini-Latch, DO NOT pull on red
Release Strap.
7. The vehicle lower anchors must
be as tight as possible. Using your
full weight, push the Base rmly
into the vehicle seat as you tighten
the lower anchors.
8. Tension LATCH/UAS Strap by
pulling on loop until snug.
9. After tightening LATCH/UAS,
secure excess strap under the
LockStrong.
CLICK!
To Next Page
Loading...
