8
Installation (continued)
FULL FLUSH WATER
ADJUSTMENT
17
□ Turn off the water supply.
□ Flush the tank to minimum residual water level.
□ Measure "L" from WL 3A to mark WL 3B in tank.
□ Turn on the water supply.
□
the setting to the next lower number and repeat. Until the
residual water level reaches WL 3B.
□ Use a pencil to mark the water level (WL3A). Ensure it is
□
a. If the water level is higher than WL3A, turn the tank water
to reset water level.
b. If the water level is lower than WL3A, turn the tank water
water level.
16
CHECK TANK WATER
LEVEL
NOTE: “L” is measured in step 4.
NOTE: Make sure water level in the bowl reaches W1 for
WL 3A
L3
Float
WL 1
Full
L
WL 3B
To Next Page
Loading...