Need help?Do you have a question about the Everbilt PCP10001-VSP and is the answer not in the manual?
General| Model | PCP10001-VSP |
|---|---|
| Motor Type | Permanent Magnet Motor |
| Type | Variable Speed |
| Horsepower | 1 HP |
| Port size | 1.5 in |
| Inlet/Outlet Size | 1.5 in |
Contact details for Everbilt Customer Service, including phone number and hours.
Details pump flow rates (GPM) at various feet of lift for different RPMs.
Explains the one-year warranty, exclusions, and purchaser responsibilities.
Covers handling flammable liquids, electrical hazards, motor housing, wet hands, safety goggles.
Details wiring, GFCI, voltage, qualified electricians, and pump placement.
Addresses fire hazard, motor temperature, piping, and electrical source adequacy.
Highlights pump durability and ventilation requirements for motor cooling.
Defines use for permanently installed pools, excluding storable portable pools.
Provides details on power supply, temperature range, and discharge size.
Emphasizes qualified personnel for installation and wiring, and pump placement.
Covers suction pipe size, piping layout, supports, and valve installation.
Details proper use of PTFE tape for threaded connections to prevent leaks.
Discusses fitting efficiency, pool suction requirements, and entrapment protection.
Covers grounding, voltage requirements, and GFCI tripping for safe electrical hookup.
Details motor grounding, bonding to pool structure, and wire specifications.
Provides step-by-step instructions and diagrams for wiring the motor correctly.
Explains bonding wire connection and permanent circuit connection with GFCI.
Addresses piping support and pump mounting for reduced strain and quiet performance.
Instructs on priming the pump before starting and essential pre-operation checks.
Guides on pump priming, routine cleaning of the trap basket, and inspecting components.
Covers procedures for draining the pump and winterizing/storage instructions.
Explains the LCD display, keypad buttons, and pump operation modes (Manual/Automatic).
Outlines the pre-set automatic schedule with time periods and operating speeds.
Details operation in Manual mode and how to set up custom schedules in Automatic mode.
Provides steps for deciding and writing down the optimal operation schedule before programming.
Step-by-step guide for programming Period 1, Period 2, and enabling Period 3 settings.
Instructions for programming Period 4, starting Automatic Mode, and changing the schedule.
Emphasizes qualified service, genuine parts, and safety before maintenance.
Details steps for disassembling the pump and removing the old shaft seal.
Step-by-step guide for cleaning, installing, and assembling the mechanical seal and pump parts.
Specifies torque values for seal plate bolts and pump body nuts during reassembly.
Identifies causes like priming issues, leaks, clogs, or worn parts and provides solutions.
Addresses electrical problems, voltage issues, piping problems, and improper mounting.
To Next Page
