Need help?Do you have a question about the Everex Magic I/O EV-170 and is the answer not in the manual?
Diagram and labels for board components and jumpers.
Factory default settings for ports and interrupts.
Step-by-step guide for rapid installation and testing.
Explains how to configure ports using jumpers and switches.
Guide to using the EV170 utility for board configuration.
Manual configuration of ports via jumpers and switches.
Details on configuring serial ports.
How to assign COM port numbers using dipswitch SW1.
Explains how to set interrupt levels for serial ports.
Explains DTE/DCE settings for serial communication.
How to enable forced control signals for serial communication.
Configuration options for the parallel port.
Details on using the parallel port as a printer interface.
How to use the parallel port for general purpose I/O.
Information about the onboard real-time clock.
How to change the I/O port address for the real-time clock.
Step-by-step guide for physically installing the board.
How to run the diagnostic software to test the installed board.
Instructions for installing and using the Everclock software.
Information about the included PC-Write word processing software.
Schematic diagram illustrating handshaking functions.
To Next Page
General