What should I do if the fishbox pump out pump runs, but does not pump out the fishbox on my Everglades 275 CC Boat?
If the fishbox pump out pump runs on your Everglades Boat, but does not pump out the fishbox, you can try to clean the strainer, fill the fishbox half full of water, then turn the pump on and off several times to move the air out and prime the pump, or clean the discharge line.
What to do if the head will not flush on my Everglades 275 CC Boat?
If the head will not flush on your Everglades Boat, you can pump out the holding tank.
Why will the holding tank on my Everglades Boat not empty?
If the holding tank on your Everglades Boat will not empty, you can try to clean the vent and vent hose, or tighten loose fittings or replace damaged hoses.
How to get rid of excessive odor from the marine head on my Everglades 275 CC?
To address excessive odor from the marine head on your Everglades Boat, you can pump out the holding tank and clean the vent and vent hose, add deodorizer to the holding tank each time it is pumped out, or pump the holding tank if it has contained waste for two weeks or more.
What to do if the baitwell pump runs, but does not pump water in my Everglades 275 CC?
If the baitwell pump runs, but does not pump water in your Everglades Boat, you can try to put the boat in reverse to clean the strainer, prime the system, or open the valve.
What should I do if the fresh water pump runs, but will not pump water in my Everglades Boat?
If the fresh water pump runs, but will not pump water in your Everglades Boat, you can try to fill the tank, replace or repair the hose, or repair or replace the pump.
What to do if the washdown pump runs but doesn't pump water on my Everglades Boat?
If the washdown pump runs but doesn't pump water on your Everglades Boat, you can try to open the valve or clean the sea strainer.
Why does my Everglades 275 CC wander and not hold a course at cruise speeds?
If your Everglades Boat wanders and will not hold a course at cruise speeds, you can try to fill & bleed the system, replace or adjust the steering tab, or grease the spindle.
Why is the hydraulic steering on my Everglades Boat slow to respond and erratic?
If the hydraulic steering on your Everglades Boat is slow to respond and erratic, you can try to fill and bleed the system, check and adjust or repair any binding component, or grease the spindle.
What to do if my Everglades Boat engine is running too hot?
If your Everglades Boat engine is running too hot, you can try to clean the pick up, repair the pump, or replace it.
Covers general safety, engine alarms, neutral safety switch, and stop switch.
Details PFDs, visual distress signals, and other essential safety gear.
Addresses bilge/fuel fires, first aid, caution/warning labels.
Explains DANGER, WARNING, and CAUTION statements.
Fields for recording boat, engine, trailer, and dealer details.
Details hull length, beam, weight, fuel, and person capacity.
Details hull length, beam, weight, fuel, and person capacity.
Details hull length, beam, weight, fuel, and person capacity.
Provides manufacturer details, identification numbers, and design category.
Explains warranty terms, registration process, and dealer assistance.
Covers boat registration, insurance responsibilities, and accident reporting requirements.
Recommends boating safety courses and outlines required safety equipment.
Covers pre-cruise checks, operator responsibilities, and navigation rules.
Details operating the boat, docking, anchoring, and mooring procedures.
Covers system failures, collisions, grounding, flooding, capsizing, and man overboard.
Safety for water skiing, wakeboarding, teak surfing, and boat trailering.
Discusses general engine care, drive system corrosion, and anode protection.
Covers cooling systems, propeller selection, and performance tuning.
Explains gauges, alarms, and fuel management systems.
Details throttle/shift controls, neutral safety, and stop switches.
Covers steering systems, trim tabs, and optional bow thruster operation.
Maintenance for steering, trim tabs, and bow thruster systems.
Covers fuel system design, tank, lines, valves, and filters.
Safe fueling procedures and ongoing fuel system maintenance.
Explains AC/DC systems, battery configurations, and switches.
Details DC system switches, circuit breakers, panels, and wiring protection.
Covers shore power connection, battery charging, and AC system maintenance.
Covers filling, priming, shower use, washdown, and routine maintenance.
Details pump operation, baitwell function, and system priming.
Covers hose checks, strainer cleaning, and pump maintenance.
Covers gravity drainage, thru-hull fittings, and cockpit sole drains.
Details bilge drainage, fishbox, baitwell, storage, and cockpit drains.
Procedures for cleaning drains, pumps, and strainers.
Discusses cabin door vents, port windows, and windshield operation.
Covers maintenance for hinges, tracks, and bilge vents.
Covers deck fittings, anchor storage, and windlass operation.
Discusses hull systems, swim platform, ladders, and cockpit features.
Covers the helm area, console, and hardtop features.
Details head compartment components for different models.
Covers toilet operation, holding tank, and waste discharge.
Covers hull cleaning, bottom painting, anodes, and hardware care.
Discusses cleaning and maintaining upholstery, canvas, and interior surfaces.
Covers bilge area, pump checks, drainage, and hydraulic system maintenance.
Guidelines for preparing the boat for storage.
Procedures for winterizing fresh water, raw water, engines, and other systems.
Steps for preparing the boat after storage.
Provides wiring diagrams for the 275/295 and 325 CC models.
Addresses issues with steering, boat handling, and engine starting.
Covers sluggishness, RPM loss, overheating, and charging issues.
Addresses issues with baitwell, fresh water, fishbox, and bilge pumps.
General| Brand | Everglades |
|---|---|
| Model | 275 CC |
| Category | Boat |
| Language | English |
To Next Page
