Evergreen Spreader+ - User Manual

To Next Page

Easy Spreader

Instructions

The EverGreen

spreader+ can be used to apply a wide range of EverGreen

and Scotts

Lawn Builder products. Refer to separate sheet for

correct settings, or visit Iovethegarden.com.

Assembly Instructions

Step 1

Insert the spreader stand into the two holes at the front of the hopper.

Step 2

Push a wheel firmly onto each end of the axle until it clicks into place.

Step 3

Insert straight ends of the arms into the handle making sure the quick release buttons securely locate into the holes of the

handle.

Step 4

Insert the ends of the handle into matching sockets at the rear of the hopper and ensure that the quick release buttons

securely locate into small hopper holes.

Parts List

• Handle

• Arms (2)

• Hopper assembly with axle and rate control lever

Need help?

Do you have a question about the Evergreen Spreader+ and is the answer not in the manual?

Summary

General