EverStart SL097 User Manual

• 10 •
9. STORAGE INSTRUCTIONS
1. Charge battery to full capacity before storage.
2. Store this unit at temperatures between
-
4°F-
+
140°F (
-
20°C-
+
60°C).
3. Never completely discharge the battery.
4. Charge after each use.
5. Charge at least once every month, if not in frequent use, to prevent
over-discharge.
10. TROUBLESHOOTING
PROBLEM REASON/SOLUTION
The jump starter turns on, but
won’t jump start my vehicle.
Make sure you have pressed the smart
cable’s button.
Verify the charge level of the jump starter is
at least 50%.
Do not attempt to jump start your vehicle
more than three consecutive times. If
the vehicle still does not start, consult a
qualied service technician.
All four LEDs ash. Low or high temperature. LEDs will stop
ashing when the condition is corrected.
The last LED ashes, then
turns off.
Over-discharge. Recharge the internal
battery.
The green LED on the smart
cable does not light when its
button is pressed.
Check connections.
If an LED is ashing, refer to the table
below. When the condition is corrected,
the smart cable will automatically reset.
Smart Cable LED Behavior
Green LED lit solid Ready to jump start
Green LED ashes three times Reverse charging protection
Red LED ashes once Reverse polarity protection
Red LED ashes twice Short circuit protection
Red LED ashes four times Low voltage protection
Red LED ashes ve times High temperature protection
Red LED lit solid
OK to press button to jump start

EverStart SL097 Specifications

General

Brand	EverStart
Model	SL097
Category	Remote Starter
Language	English