Everwarm EWPO2430PV User Manual

INSTALLATION AND OPERATION INSTRUCTIONS
UNVENTED (VENT-FREE) GAS LOG HEATER
REMOTE CONTROL READY BURNER SYSTEM
MODELS
EWPO2430NV AND EWPO2430PV,
FOR USE WITH:
EWPO18R, EWPO24R, EWPO30R AND
EWLCT18R, EWLCT24R, EWLCT30R LOG SETS
Also Design-Certified As Vented Decorative
Appliances
PFS
®
US
P/N 126345-01 Rev D 11/2016
REPORT NO. F09-129
P126345-01
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
This appliance may be installed in an aftermarket permanently located, manufactured (mobile) home,
where not prohibited by local codes. This appliance is only for use with the type of gas indicated on the
rating plate. This appliance is not convertible for use with other gases.
This is an un-vented gas-fired appliance. It uses air (oxygen) from the room in which it is installed. Provisions
for adequate combustion and ventilation air must be provided. Refer to Air for Combustion and Ventilation
section on page 5 of this manual.
WARNING: If the information in these instructions is not followed exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
WARNING:
FIRE OR EXPLOSION HAZARD
Failure to follow safety warnings exactly could result in serious injury, death, or property damage.
— Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other
appliance.
— WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Leave the building immediately.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire department.
— Installation and service must be performed by a qualified installer, service agency or the gas
supplier.

Everwarm EWPO2430PV Specifications

General

Brand	Everwarm
Model	EWPO2430PV
Category	Gas Heater
Language	English

Summary

Air for Combustion and Ventilation

Confined and Unconfined Space

Defines confined and unconfined spaces for air calculation per NFGC.

Determining Fresh-Air Flow for Heater Location

Outlines the method to calculate required ventilation air based on space volume.

Installation

Installation and Clearances for Vent-Free Operation

Details mandatory clearances for safe vent-free operation of the heater.

Installing Heater Base Assembly

Guides the user on securely mounting the heater base assembly into the fireplace.

Connecting to Gas Supply

Provides instructions and warnings for safely connecting the gas supply to the heater.

Checking Gas Connections

Details procedures for leak testing all gas connections to ensure safety.

Installing Logs

Detailed instructions for correctly positioning the logs on the burner assembly.

Operation

For Your Safety Read Before Lighting

Essential safety precautions and steps before attempting to light the appliance.

Lighting Instructions

Step-by-step guide on how to safely light the pilot and burners.

To Turn Off Gas to Appliance

Instructions on how to safely turn off the gas supply to the appliance.

Specifications

Service Hints

Offers advice on common issues related to gas pressure and performance.

Accessories

Fireplace Hood

Explains the purpose and adjustability of the fireplace hood accessory.

Wall-Mount Thermostat Switch

Describes the wall-mounted thermostat for controlling heater settings.

Damper Clamp

Details the clamp used to permanently open the chimney flue damper.