Need help?Do you have a question about the Evh 5150III-LBXII and is the answer not in the manual?
General| Brand | Evh |
|---|---|
| Model | 5150III-LBXII |
| Category | Amplifiers |
| Language | English |
Plug guitar in here using only a high-quality shielded instrument cable.
Pushbutton selects clean channel (GREEN) when in; selects crunch channel (BLUE) when out.
Dual concentric gain controls for clean (inner knob) and crunch (outer knob) channels.
Low, mid, and high-frequency tone controls for both channels.
Dual concentric volume controls for clean (inner knob) and crunch (outer knob) channels.
Ultra-high frequency tone control applicable to both channels.
Indicates amplifier status when illuminated.
Connect the included power cord to a grounded outlet matching voltage/frequency ratings.
Replace blown fuses only with specified type and rating, with power disconnected.
Turns the amplifier on and off. Use STANDBY for tube warm-up.
Puts amp in standby to prolong tube life or takes it out of standby.
Sets maximum output power or reduces it to approximately four watts.
Connect SEND to effects input and RETURN to effects output.
Connect the single-button footswitch for channel switching.
Adjusts the power amp's low-frequency response.
Selects output impedance (4, 8, or 16 ohms) for speaker matching.
For connection to a speaker cabinet. A speaker must always be plugged in.
To Next Page