GENERAL KNOWLEDGE
1. This cycle should always be placed on a level surface for use. You may raise or lower
the bike by adjusting the four leveling bolts (16).
2. Adjust Seat (22) to a suitable position by adjusting Seat Sliders (3) and Seat Post (2).
And please adjust height of Handlebar (4) according to your body size.
3. Set the correct resistance by Adjusting Knob (11) please set a right resistance
according to your requirement.
4. The drive mode of the equipment is bi-directive drive. Please press Brake Handle (9)
for braking when aggressive exercise is performed and it will stop immediately. Do
not leave the seat until all parts come to a complete stop.
To Next Page
Loading...