7.6 Copy Counter
This operation will record duplicated quantity, and total number of successful and unsuccessful CD/DVD.
The default setting of counter is off.
7.6.1 Show Count. Displays the disc type followed by Passed and Failed Disc Count
7.6.2 Enable Counter. Enable (default) or Disable the Copy Counter
7.6.3 Clear Counter. Reset the Copy Count to zero for all disc types.
7.7 Update BIOS
This operation will update your duplicator’s firmware. Use only under instruction of technical support.
7.8 Print LS Label
8. SETUP
8.1 Auto Start Time
When the duplicator detects master and blank discs have been inserted, the system will automatically
start copying. The system default of auto-copy is 5 seconds after detected master and blank discs. You
can turn off this function or reset the auto start time between 1 and 99 seconds.
8.2 Display Mode
There are three modes: Show Speed, Basic, and Show Timer. The default setting of display mode is
Show Speed.
Show Speed displays the real time burning speed, percentage of progress and MB burned. The Basic
mode will display percentage of progress and MB burned. Show timer mode will display elapsed time,
percentage of progress and MB burned.
8.3 Button Beep
You can choose whether or not to hear a beep when pressing any button. Default is ON
8.4 Eject On Start
Under this operation, you can set the behavior of the trays upon startup. Eject All Disc is default. Other
options are Do Not Eject, Eject Target Only, Eject Source Only, and Eject All Trays.
8.5 Reader Speed
This feature will allow you to set the maximum reading speed of the master drive for the following disc
types- CD, DVD, BD
8.6 Compare Speed. This feature will allow you to set the maximum reading speed of all drives when running
Compare for the following disc types- CD, DVD, BD
8.7 Language
Set system language interface, English is default, Other options are Spanish, Portuguese, Japanese,
German, French and Italian.
8.8 Clear Setup
Reset all of the operations and back to the manufacturer’s default setting.
8.9 Advanced Setup
8.9.1.1 Power On Time
You can set the system warm up time from 1 second to 99 seconds after system power on.
Default is 15 seconds.
8.9.2 Startup Menu
You can select which function on the screen when turned on the duplicator; the default screen is
“1.COPY”.
8.9.3 Skip Read Error
When enabled any reading error from the master disc is ignored and the copy process will
attempt to continue. Default setting is Yes
8.9.4 Change Bad Master Disc
When enabled the system will eject any bad master disc to ask for another disc when the master
disc is unreadable. Default is Enabled
8.9.5 CD Overburn
This feature will allow you to burn more data than standard disc space. Default is Disabled.
To Next Page
Loading...