How to fix E08 communication failure on evoheat Swimming Pool Pump?
E08 indicates a communication failure between the wire controller and the main board of your evoheat Swimming Pool Pump. To resolve this, check the connection between the wire controller and the main board.
What to do if my evoheat Heat Pump displays a Flow Switch Prot. error?
If your evoheat Heat Pump shows a Flow Switch Prot. error, it means there is no water or very little water in the water system. You should check the pipe water flow and the water pump to ensure adequate water supply.
Why is my evoheat Heat Pump showing High Pressure Prot.?
If your evoheat Heat Pump is showing a High Pressure Prot., it could be due to a broken high-pressure switch. Check the pressure switch and cold circuit to resolve this issue.
What is E29 error on evoheat DHP20-R Swimming Pool Pump?
The error code E29 on your evoheat Swimming Pool Pump indicates secondary antifreezing protection. This occurs when the ambient temperature is too low.
How to fix P01 error on evoheat DHP20-R?
The error code P01 on your evoheat Swimming Pool Pump indicates a water inlet temperature sensor failure. This is likely due to the temperature sensor being loose or faulty. Check or change the sensor to resolve this issue.
What does E03 water flow protection mean on evoheat DHP20-R?
The error code E03 on your evoheat Swimming Pool Pump indicates water flow protection. This is likely because the flow switch is loose or faulty. Check or change the sensor.
How to fix Suction Temp. Sensor Fault on evoheat Heat Pump?
If your evoheat Heat Pump displays a Suction Temp. Sensor Fault, it means the temperature sensor is broken or short circuit. Check or change the temperature sensor.
How to fix Discharge Temp. Sensor Fault on evoheat Heat Pump?
If your evoheat Heat Pump displays a Discharge Temp. Sensor Fault, it means the temperature sensor is broken or short circuit. Check or change the temperature sensor.
How to resolve E06 temperature difference error on evoheat DHP20-R?
The error code E06 on your evoheat Swimming Pool Pump indicates a temperature difference between the inlet and outlet. If the temperature difference is greater than 13, ensure it is less than 13 and power off the unit.
What causes a Fan Motor2 Fault in my evoheat Heat Pump and how do I fix it?
A Fan Motor2 Fault in your evoheat Heat Pump can be caused by: 1. Motor is in locked-rotor state. 2. The wire connection between the DC-fan motor module and fan motor is in bad contact. To solve this: 1. Change a new fan motor. 2. Check the wire connection and make sure they are in good contact.
Lists key technical data and features for DHP R models.
Outlines critical checks before installation, including airflow and water flow.
Covers essential electrical connection requirements and safety.
Specifies optimal site placement and required clearance for the unit.
Details plumbing requirements and water flow considerations for optimal performance.
Provides specific wiring instructions and safety device requirements.
Lists all unit parameters, their codes, settings, and defaults.
Accessing and interpreting error codes for troubleshooting.
Guidance on diagnosing and resolving typical operational problems.
A detailed table of error codes, their reasons, and solutions.
Details the terms, conditions, and duration of the pump warranty.
General| Brand | evoheat |
|---|---|
| Model | DHP20-R |
| Category | Swimming Pool Pump |
| Language | English |
To Next Page