Evoke BREAKAWAY 125 - Material and Boat Setup; Kayak Material; Folding Seat Installation; Paddle Holder

4
Revision A:_ 3/28/19
MATERIAL
Your kayak is manufactured from Ultra High Molecular Weight High Density Polyethylene (UHW HDPE). It is a very durable material. Our specically formulated
UHW HDPE has an ultra-violet inhibitor blended throughout the material to reduce color fade and maintain its strength. Polyethylene is a somewhat exible
material with some memory. This means it has a tendency to return to its original molded shape if distorted.
BOAT SET-UP
NOTE: Models vary and may not come equipped with the features below:
Folding Seat
Make certain seat bolts are installed at mounng rails/inserts ensuring the folding seat is secured in place. - see step 8 on page 12
Paddle Holder
Paddle can be secured in bungee paddle straps on each side of hull.
Drain Plug
Ensure drain plug is secured in place.
Pedal Drive Propeller, Rudder & Cable System
See Installaon & Care on pages 6 thru 11.
Manufacturers Statement of Origin (MSO)
You should receive a MSO with your new kayak. Some states may require a MSO for proper kayak registraon. Please check with your local licensing bureau.
Applying Registraon Decals
Before applying kayak registraon decals (if required), clean the area with alcohol or solvent that does not leave residue. Make sure the solvent is put aside and
the decal area is dry. Using a propane torch, lightly pass the ame back and forth over area where the decal(s) will be applied. Do not try to heat decal’s surface.
This procedure alone will enhance the adhesion of decals.