Evolur SANTA FE - Conversion to Full Size Bed; Footboard Removal for Full Size Bed; Removing Mattress Support and Panels

17
www.evolurbaby.com/help
3
CONVERSION MODES - FULL SIZE BED ASSEMBLY
3a. In order to convert the
crib to a Full-Size bed,
you must first remove the
Footboard of the crib.
3b. Remove the Mattress
Support Panel, followed
by Left and Right Panels.
3c. Make sure to follow the
complete instructions
provided with Bed Rails.
Bed Rails (NOT INCLUDED, SOLD SEPARATELY)
NOTE:
*Make sure to use the
Evolur Bed Rails
(SKU-812) in order to
convert the crib to a
Full-size Bed with
Footboard.
*Do not put the mattress
directly on the wooden
slats, use either a Bunky
Board, Particleboard, or
low-profile Boxspring
before placing the
mattress.