To Next PageTo Next Page
Need help?Do you have a question about the Evolur SANTA FE and is the answer not in the manual?
General| Assembly Required | Yes |
|---|---|
| Product Category | Crib |
| Type | Convertible Crib |
| Convertibility | Yes |
| Converts to | Toddler Bed, Daybed, Full Bed |
| Safety Standards | JPMA certified; meets ASTM and CPSC standards |
Covers adult assembly, choking hazards from small parts, and checking for damaged or missing components.
Covers failure to follow instructions, SIDS reduction, product checks, and using replacement parts.
Details risks from strings, cords, loose fasteners, and gaps, with specific mattress size requirements.
Advises on mattress position, removing climbing aids, and when to stop using the crib due to child's height.
Prohibits use if instructions cannot be followed, for children over 90cm, or with cords/straps near the crib.
Specifies mattress thickness (max 15cm) and size to prevent dangerous gaps between mattress and crib sides.
Warns against soft bedding like pillows or comforters, as they can cause suffocation.
Instructions for aligning the Left and Right Front Legs with the Footboard.
Details on inserting bolts (A and E) into leg holes and tightening them with the Allen key (C).
Guidance on aligning the Left and Right Side Panels to the Footboard.
Instructions for inserting and tightening four bolts (B) using the Allen key (C).
Instructions to attach the Mattress Support Panel to the Footboard and Side Panels using bolts (D).
Procedure to align the Left Rear Leg with the Headboard and secure it with bolts (F) using the Allen key (C).
