To Next PageTo Next Page
Need help?Do you have a question about the Evolur STILNOVO MID CENTURY and is the answer not in the manual?
General| Product Type | Crib |
|---|---|
| Product Name | Evolur STILNOVO MID CENTURY |
| Category | Baby & Toddler Furniture |
| Style | Mid-Century Modern |
| Number of Mattress Height Positions | 3 |
| Color Options | Multiple |
| Weight Capacity | 50 lbs |
| Adjustable Height | Yes |
| Convertible | Yes |
| Converts to | Toddler Bed |
| Safety Features | Non-toxic Finish |
| Material | Solid Wood |
Requires adult assembly, read instructions, avoid drills, check parts, use soft surface.
Beware of small parts, suffocation hazards, and use recommended mattress.
Clean with damp cloth. Contact support for assistance.
Covers 1 year for defects; requires proof of purchase; limited to parts/replacement.
Excludes misuse/alteration. Grants specific legal rights varying by state.
Follow instructions, adult assembly, check parts, avoid drills, use soft surfaces, prevent strangulation/suffocation.
Beware of small parts, SIDS, falls, and mattress fit. Stop use if child climbs or exceeds height limit.
Proper storage, climate control, avoid vaporizers, follow instructions exactly, and mattress gap rules.
Identifies leg support plates, legs, front bar, side panels, headboard, and footboard.
Identifies the mattress support panel.
Lists all bolts, washers, nuts, and the Allen key required for assembly.
Assemble front and rear legs to leg support plates using bolts and washers.
Tighten all leg assembly bolts using the provided Allen Key.
Align and attach the Front Bar to the assembled legs with bolts.
Tighten all bottom frame bolts using the Allen Key.
Align and attach the Left and Right Side Panels to the bottom frame with bolts.
Tighten all side panel bolts using the Allen Key.
Align and attach the Headboard Panel to the side panels using bolts.
Tighten all headboard bolts using the Allen Key.
Attach mattress support to panels; secure with bolts and tighten.
Select height based on infant's age and development stage.
Align and attach the Footboard Panel to the side and front panels with bolts.
Tighten all footboard bolts using the Allen Key.
Remove footboard; attach bolts and nuts to side panels.
Tighten bolts and ensure mattress support is at the lowest position.
Remove footboard; attach stabilizer bar and guard rail using bolts.
Follow guard rail instructions; ensure low mattress support; use specific Evolur guard rail.
Remove footboard, panels, and legs; use specific Evolur bed rails.
Do not place mattress directly on slats; use a bunky board or box spring.
Control room climate (temp/humidity), avoid direct sunlight, store in dry areas, lift when moving.
Clean with damp cloth/mild soap. Protect surfaces; do not over-polish, wax, or use vaporizers.
