GRAVITY FED INSTALLATION INSTRUCTIONS
23
CLEANING PROCEDURE
For cleaning instructions, refer to the red cleaning guide supplied with your Nexus or follow
the instructions below:
1. Switch the circulation pump off. Wait for 1 minute.
2. Insert the inlet slide plate.
3. Insert the cleaning pipe into the centre of the Eazy.
4. Open air valve to the inner chamber.
5. Close the air valve to the outer chamber.
6. Allow the K1 Micro in the Eazy to agitate for 5 minutes.
7. Open the larger waste valve and wait for the inner chamber to empty.
8. At this stage you may want to hose down any debris from underneath the Eazy.
9. Close the waste valve.
10. Open the air valve to the outer chamber.
11. Close the air valve to the inner chamber.
12. Remove the inlet slide plate and wait until the inner chamber has filled with water.
13. Once inner chamber has filled, remove the cleaning pipe.
Steps 2 to 13 should be repeated until the Eazy is clean. It is likely that you will need to do
this 2 to 3 times depending on your pond.
14. Switch the circulation pump on.
To Next Page
Loading...