ⅱ.Electric components maintenance
Check the headlight back rubber caps , the caps should
always be kept on tightly . otherwise water or dust may
enter into the headlight chambers .
Cause halogen bulbs burn down easily and vague vision
of headlights .
Keep the controller from water , water may cause
circuitry short circuit . If water enter into controller , the
vehicle may run unintentionally after turn on the
power switch.
Keep LED rear lights waterproof , keep the cover lid
tight ,keep dust and water out of LED light assembly .
Dense humidity or water may cause LED diodes to
burn down .
DO NOT LOAD LED LIGHTS WITH HIGH VOLTAGES .
Check fluid level before and after charging , electrolyte
should be at least 1/2”(13mm)above the plates and
1/4” tp3/8”(6 to 10mm) below bottom of the vent .
NEVER CHARGE BATTEY WITH LITTLE ELECTROLYTE , IT
MAY CAUSE OVERHEATED OR EVEN EXPLOSION
To Next Page
Loading...
