Evolution X - Evolution-X Starter Kit Assembly; Standard Evolution-X Starter Kits; Mega Evolution-X Starter Kits

Standard Evolution-X Starter Kits
Standard Evolution-X electronic cigarettes have four pieces:
1. An Evolution-X Battery : It is the longest piece and has a button on it.
2. A 510 Atomizer : It is tube-shaped, approximately an inch long and is the only piece that can
screw into the inner threads of an Evolution-X battery.
3. An Evolution-X Cone : It is a little longer than the atomizer, metal, hollow, cone shaped and is
the only piece that can screw into the outer threads of an Evolution-X battery.
4. A 510 Cartridge : It is plastic, about an inch long and has a fibrous material inside of it.
Assembling a Standard Evolution-X Starter Kit is quite easy. Here's all you need to do:
1. Screw the Evolution-X battery onto the 510 atomizer. DO NOT SCREW THE TWO PIECES
TOGETHER TOO TIGHTLY; stop when there is any resistance. Screwing a 510 atomizer onto
an Evolution-X battery too tightly could force the post of the battery down into the battery
where it will no longer be able to make proper contact with the atomizer or the battery charger.
2. Unwrap one of the five cartridges that came with your Evolution-X Starter Kit. All of our
Standard Evolution-X Starter Kits come with unfilled cartridges and a bottle of e-liquid that you
use to fill the cartridges. Please see the section, below, about how to fill your Evolution-X e-
cigarette cartridges. Once you have filled your cartridge, simply push it onto the open end of the
atomizer (the other end should already be screwed onto the battery).
3. Slide the Evolution-X cone over the cartridge and atomizer, big side down (the side with the
screw threads toward the battery). Screw the cone cover onto the outer threads of your
Evolution-X battery.
Note: an Evolution-X cone is simply a cosmetic piece that gives an Evolution-X a tapered
appearance; it serves no function. Some people do not use the cone at all!
Your Standard Evolution-X is now assembled and ready for use!
Mega Evolution-X Starter Kits
Mega Evolution-X electronic cigarettes have three pieces:
1. An Evolution-X Battery : It is the longest piece and has a button on it.
2. A Mega Atomizer : It is cone-shaped, metal, approximately 1½ inches long and is the only piece
that screw onto an Evolution-X battery.
3. A Mega Cartridge : It is plastic, about 1½ inches long, has a wide flat mouthpiece and fibrous
material inside of it.
Assembling a Mega Evolution-X Starter Kit is even easier. Here's how you do it:
1. Screw the Evolution-X battery onto the Mega atomizer. DO NOT SCREW THE TWO PIECES
TOGETHER TOO TIGHTLY; stop when there is any resistance. Screwing a Mega atomizer
onto an Evolution-X battery too tightly could force the post of the battery down into the battery
where it will no longer be able to make proper contact with the atomizer or the battery charger.
2. Unwrap one of the five Mega cartridges that came with your Evolution-X Starter Kit. All of our
Mega Evolution-X Starter Kits come with unfilled cartridges and a bottle of e-liquid that you
use to fill the cartridges. Please see the section, below, about how to fill your Evolution-X e-
cigarette cartridges. Once you have filled your cartridge, simply push it onto the open end of the
cone (the other end should already be screwed onto the battery).