a bottle of e-liquid that you will use to fill your cartridges with. The way you fill a cartridge is a little
bit different, depending on the type of Evolution-X Starter Kit that you purchased.
Filling a Standard Evolution-X Cartridge with E-Liquid
1. Remove the Evolution-X 510 cartridge from the package and also remove the protective
rubber cap that is on the "gauzy" side of the cartridge. Throw the rubber cap away.
2. Drip e-liquid from your bottle one drop at a time onto the filler material until it begins to
look like a slushy. Typically, this is at least 15 drops with a brand new 510 cartridge.
3. Push the side that you just filled onto the open end of the 510 atomizer. The side of the
510 cartridge with the very small pinhole is the side you inhale through.
Filling a Mega Evolution-X Cartridge with E-Liquid
1. Remove the Evolution-X Mega cartridge from the package and also remove the
protective rubber cap that is on the "gauzy" side of the cartridge. Throw the rubber cap
away.
2. Drip e-liquid from your bottle one drop at a time onto the filler material until it begins to
look like a slushy. Typically, this is about 40 drops with a brand new Mega cartridge.
3. Push the side that you just filled onto the open end of the Mega atomizer. The flat tipped
side of the Mega cartridge is the side you inhale through.
* TIP For Users of Evolution-X Standard or Mega Cartridges: A new Standard or Mega Evolution-
X cartridge frequently won't sop up as much e-liquid as it can really hold. To get as much liquid as you
can into an Evolution-X standard or Mega cartridge, add drops until it starts to pool. Next, attach the
cartridge to your Evolution-X e-cigarette and, holding the battery end in your hand with the cartridge
facing toward the floor, shake the e-cigarette several times downward, like you are shaking the mercury
down in a thermometer. This will force the e-liquid down in the mouthpiece. Then, pull the cartridge
off of the Evolution-X and it should hold a few more drops. Please keep in mind that you can do this
too much or too hard. If you notice that you are getting e-liquid in your mouth, you may have shaken
the juice too far down into your cartridge, past the filler material or you may have overfilled it.
Topping Off an Evolution-X Standard or Mega Cartridge
You will need to frequently "top off" your Evolution-X e-cig cartridge when it starts drying out and not
producing as much vapor (or when it starts to taste more like an old rag). Depending on how large a
drag you take, how frequently you will have to do this varies with each individual, but typically, it's
about every 25 drags or so.
1. Remove the Cartridge from the atomizer.
2. Add 3 to 4 drops or as many as it takes to make it look like a slushy.
3. Push the cartridge back onto your Evolution-X atomizer.
The Three Rules of a Perfectly Filled Standard or Mega Cartridge
There are only three things you need to keep in mind when filling your Evolution-X e-cigarette
cartridges, whether they are brand new cartridges or you are topping one off:
1. If it looks like a piece of gauze inside, it needs more e-juice.
2. If it looks like a little pond, it has at least one drop too many (not a big deal).
To Next Page
Loading...