To Next PageTo Next Page
Need help?Do you have a question about the EVOLV DNA 75 and is the answer not in the manual?
General| Chipset | DNA 75 |
|---|---|
| Output Power | 1W - 75W |
| Temperature Control | Yes |
| Resistance Range (Temperature Control) | 0.08Ω - 1.0Ω |
| Resistance Range (Wattage Mode) | 0.1Ω - 3.0Ω |
| Firmware | Upgradable |
| Threading | 510 |
| Temperature Control Range | 200°F - 600°F |
| Supported Wire | Nickel, Titanium, Stainless Steel |
| Battery Type | Single 18650 |
| Weight | 120g (without battery) |
Key technical specifications including output power, voltage, current, resistance, and dimensions.
Specifies the minimum, typical, and maximum output power.
Details the voltage range supplied to the atomizer.
Defines the continuous and peak current capacities.
Specifies resistance ranges for different wire types.
Defines the adjustable temperature limit for protection.
Specifies the acceptable input voltage range.
Details the input current requirements.
Indicates the device's operational efficiency.
Provides key physical measurements: footprint, thickness, screen size.
Explains how the DNA 75 measures and limits coil temperature to prevent overheating.
Provides step-by-step instructions for setting the maximum temperature limit.
Details how to switch between Celsius and Fahrenheit temperature units.
Describes the Preheat feature for faster vapor production.
Guidance on connecting atomizers and confirming changes.
Illustrates the output power range based on coil resistance.
Covers waking the device, generating vapor, and adjusting settings.
Explains the OLED screen and the data it displays.
Lists customizable data fields for the display via Escribe.
Enables locking the device to prevent accidental adjustments or firing.
Turns off the display for discreet operation.
Locks power settings while allowing normal operation.
Locks the atomizer resistance for accurate temperature measurement.
Allows adjustment of the maximum temperature limit.
Explains saving and selecting up to eight groups of output settings.
Instructions on how to select different coil materials for profiles.
Lists and explains error messages like Check Atomizer, Shorted, Weak Battery.
Explains 'Temperature Protected', 'Ohms Too High/Low' messages.
Describes the 'Too Hot' message for excessive board temperature.
Details how the screen dims and the device enters sleep mode.
Describes the 1A USB charger and its auto-detection capabilities.
Explains the system that monitors battery state and health.
Details the Escribe software for configuration, monitoring, and modification.
Lists pin numbers, names, and their functions for connecting components.
Provides guidance on appropriate wire gauges for different connections.
Discusses recommendations for fire/up/down buttons and battery types.
Explains the built-in protection against incorrect battery insertion.
Step-by-step guide for connecting the OLED screen using a ZIF socket.
Describes the three mounting holes designed for #0 screws.
Explains using mounting pads for grounding and chassis connection.
Presents detailed drawings with measurements of the DNA 75 PCB.
