EVVO INTENSA 20 - Steam Milk Foam Function; Initiating Milk Frothing and Preheating; Milk Addition and Steam Activation; Stopping Frothing at Optimal Temperature

CAFETERA ESPRESSO EVVO INTENSA 20/20S
23
ENGLISH
1. Press “ ” ON/OFF button and then” ” milk frothing button. At this time, the
“ ” milk frothing button indicator starts ashing until the indicator turns on
normally and the preheating is completed.
2. Pour the iced whole milk into the milk pitcher 1/3 of the way, insert the steam nozzle
1CM into the milk surface, then slowly unscrew the “steam control knob” until the
steam starts to come out. (Fig.5)
(Note: Steam can be adjusted according to personal prociency. Release a little water
in the steam pipe before foaming)
3. When the temperature of milk reaches about 75 degrees and the milk foam begins
to inate, you can twist the “steam control knob” to “OFF” and press “ ” milk
frothing button to close.
6. Hot water function
Press the “ ” switch, turn the “steam knob” to” ”, and the steam pipe starts to
continuously discharge hot water; Turn the “steam knob “ to” OFF “stop the hot water.
Additional function -- memory coffee making function
1.After the machine is heated up (when the “ ” and “ “ indicator lights become
stay on, press and hold the “ “ for 3 seconds at the same time , and the funnel
starts to pour coffee. When the desired amount is reached, then press the “ ”
button, you will listen a sound from the machine. That means the time has been
memorized. The next time you press the “ ” button, press this time to make coffee
(the longest time is 60 seconds, The setting is invalid for more than 60 seconds,
remaining at the default time.) Single cup ow is set to 40~60ml.
2.” ”Key memory function setting is the same as above.Double cup ow setting
value is 80~110ml.
3.Restore factory Settings: press and hold “ ” +” ”for 3 seconds at the same
time. When both keys are on and ringing 1 times, reecting the factory settings have