LAVADORA EVVO NOVA 8/9/10/11/12 X
9
• The appliance must not be installed behind a lockable door, a sliding door or a
doorwith a hinge on the opposite side to that of the washer.
• Remove all packaging material and transport bolts before using the appliance.
Otherwise, serious damage may result.
• This appliance is equipped with a single inlet valve and can be connected to the cold
water supply only.
• Mains plug must be accessible after installation.
• Before washing clothes for the first time, the product shall be operated once
throughout all the procedures without any clothes inside.
• Before using the washer, the product shall be calibrated.
• Do not put any excessively heavy objects on the appliance, like water containers or
heating devices.
• The new hose-sets supplied with the appliance are to be used and that old hose-sets
should not be reused.
• Max. Inlet water pressure 1 MPa. Min. inlet water pressure 0.05 MPa
• Make sure the supply cable is not trapped by the machine, it can get damaged.
• Connect the product to a grounded outlet protected by a fuse complying with the
values in the “ Technical specifications“ table. The grounding installation has to be
made by a qualified electrician. Ensure that the machine is installed in accordance
with the local regulations.
• Water and electrical connections must be carried out by a qualified technician in
accordance with the manufacturer‘s instructions and local safety regulations.
WARNING!:
• Don´t use multiple plugs or extension cords.
• The appliance must not have an external switching device such as a timer or
connected to a circuit that is regularly switched on and off.
• Do not pull the plug out of the mains outlet if there is flammable gas around.
• Never pull out power plug with wet hands.
To Next Page
Loading...