exacqVision Surveillance Keyboard Guide
+1.317.845.5710
+5255.56080817
+44.1438.310163
+31.485.324.347
USA (Corporate Headquarters)
Mexico
Europe/Middle East/Asia
Central Europe
1
This document is supplemental to the quick start guide and the user manual shipped with your system. Both documents can
be downloaded at https://www.exacq.com/support/specsheets.html.
Most systems can be configured with the following steps:
1. Install exacqVision Client.
2. Plug the exacqVision Surveillance Keyboard into an available USB port.
3. In exacqVision Client, browse to the Joystick Setup page under Client Setup in the site tree in exacqVision Client. The
joystick is listed as “Exacq Joystick” in the drop-down list.
4. Configure the Position and Zoom controls and calibrate as desired.
5. The keyboard buttons map with the following defaults (see the following page for a visual button mapping):
6. Press each keyboard button to test the mapping. If configured correctly, each red button changes to green when
the mapped button is pressed.
7. You can change button actions as desired by selecting them from the drop-down lists. Click Apply when finished.
To Next Page
Need help?
General
