EXCEL DRYER, INC 1.800.255.9235 EXCELDRYER.COM ADMIN@EXCELDRYER.COM
357 CHESTNUT STREET, EAST LONGMEADOW, MA 01028
9/2018
1
ThinAir
®
HAND DRYER
INSTALLATION AND OWNER’S MANUAL
Dryer Model
Serial Number
Date Of Purchase
MODELS: TA -
ABS
Hand Dryer Tamper-Proof Wrench
Knockout Gasket
Installation and Owner’s Manual
CONTENTS OF BOX
1 2 3
120V 8 Amp
MODEL INFO
208–240V 4 Amp
230V 3.9 Amp
SB
EN
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
A. Use this unit only in the manner intended by the manufacturer.
B. Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting
means to prevent power from being switched on accidentally. When the service disconnecting means
cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.
CLEANING / MAINTENANCE
OUTSIDE: Gently wash Cover (including air inlet holes)
using a soft cloth or sponge and a mild soap or
detergent with lukewarm water to loosen dirt
and grime.
INSIDE: Excel recommends inspecting the inside of the
dryer and cleaning as required at least once per
year, or if performance diminishes. Heavier usage,
or an environment that contains excessive lint,
dust or other particles, requires more frequent
cleaning. Lint on the air inlet, the Pre-Filter, or
other internal parts of dryer will reduce efciency
and shorten the life of the working parts.
TO CLEAN: Shut off power to dryer at service connection.
Uses the Tamper-Proof Wrench supplied and
remove the Tamper-Proof Bolt on bottom of cover
lifting upwards to remove cover from base plate.
Gently clean all parts using a small, soft brush.
Unclip the Pre-Filter, rinse with water and dry.
Re-install.
MOUNTING DETAILS
READ AND SAVE THESE INSTRUCTIONS
To Next Page
Need help?
General