EXCURSION SX6C - Pre-Installation Instructions; Mounting Location and Cavity Depth; Clearance Check for Mounting; Installation Method and Execution

3
EXCURSION
It is recommend that you have your new EXCURSION SX Series Automove
Speakers professionally installed by your authorizied EXCURSION dealer. This
will ensure use of proper installaon techniques and materials and save much
me and efforts. If you choose to perform your own installaon, the following
instrucon will give you direcon toward making your purchase complete. Read
the following informaon and precauons carefully. Failure to follow the stated
precauons may result in personal injury or damage the audio system or vehicle.
A.) Always make sure the speaker will easily fit into the intended mounng locaon
and that there is adequate cavity depth to accept the magnet structure.
B.) Check for adequate clearance between speaker and window, window crank,
power window mechanism, seat, glove box, rear deck torsion bars and other
items which may interfere with the speaker`s mounng. This is especially
important if any hole cung is required. Complete speaker, mounng size and
depth requirements can be found on page 9 of these instrucons. A good way to
confirm speaker place meet on a door or body panel is to place the speaker`s
die cast mounng ring onto the surface. Check for a flat mounng surface,
free from all obstrucon.
C.) The method of installaon choosen and level of execuon will effect the
overall performance of the EXCURSION Speakers. Thread each installaon
step with a high degree of aenon.
D.) Do not mount the speaker where water may splash the woofer cone.
A plasc cup or some heavy gauge plasc sheeng may be needed in some
locaons that are exposed to moisture from behind the body panel.
E.) Care must be taken to prevent low frequency cancelaon caused by air
leakage between the front and rear of the speaker (such as when mounted
on a curved or uneven surface, or when mounted in an oversized hole)
F.) Mounng panel reinformcement may be necessary in some cases in order
to prevent surface flex. This can be achieved by mounng the speaker on a
metal or wooden sub-baffle behind the body or door panel.
Consult an installaon specialst for further direcon.
Pre-Installaon Instrucons: