What to do if Exgain E1800S Lawn Mower stops working and beeps?
If your Exgain Lawn Mower stops working and beeps, it's likely because the mower is tilted more than 30 degrees from the ground. To resolve this, turn off the mower, move it to level ground, and then restart it.
Why Exgain E1800S does not complete the edge?
If your Exgain Lawn Mower does not complete the edge, it is probably due to an obstacle along the path. To fix this, observe the full operation of the mower following the virtual wire and make sure there are no obstacles present.
What to do if Exgain E1800S Lawn Mower does not detect the charging station contacts?
If your Exgain Lawn Mower isn't detecting the charging station contacts, it might be because the ground before the charging station isn’t flat. Try resetting the charging station in a flat place.
What to do if Exgain E1800S reaches charging station when its contacts are above the charging sheets?
If your Exgain Lawn Mower reaches the charging station with its contacts above the charging sheets, it's likely due to a height difference between the charging station and the lawn surface at the entrance. Confirm that the ground before the charging station is leveled with the station; if necessary, fill the area with dirt and level it off.
How to fix anomalous behavior of Exgain E1800S Lawn Mower around flower beds?
If your Exgain Lawn Mower is behaving anomalously around flower beds, it's probably because the virtual wire is incorrectly placed. Relocate the virtual wire to correct this.
Why is my Exgain E1800S so noisy?
Your Exgain Lawn Mower might be very noisy due to several reasons. It could be a damaged cutting blade, which requires replacement with a new one. Alternatively, the cutting blade might be flooded by residues like tapes, ropes, or plastic fragments; in this case, stop the mower safely, use protective gloves to remove the cause from the blade. The noise can also appear if the mower started too close to obstacles (less than 1m away) or unexpected obstacles such as fallen branches. Try starting the robot in a new place. A damaged running motor may also cause the noise, requiring repair or replacement by a service station. If the grass is too high, increase the cutting height. In some cases, you might need to use a normal lawn mower, especially if increasing the cutting height or cutting motor...
Provides crucial safety guidelines for operating the mower.
Details the various features and functions of the E1800 model.
Details the process and best practices for installing the charging station.
Explains how to install the virtual boundary wire.
Guidelines for creating islands and setting up sharp corners with virtual wire.
Detailed instructions on how to start the robot mower.
Methods for stopping or turning off the mower.
Explains how to use the emergency stop function.
Dividing the lawn into multiple working areas for efficiency.
Setting up a weekly mowing schedule for different areas.
Step-by-step guide for replacing mower blades.
Solutions for when the mower fails to start.
Troubleshooting steps for unexpected mower stops and beeping.
Addresses issues related to the mower being over-tilted.
Solutions for battery recharging problems.
How to fix issues with the mower not reaching the lawn edge.
Troubleshooting for charging station contact detection failures.
General| Brand | Exgain |
|---|---|
| Model | E1800S |
| Category | Lawn Mower |
| Language | English |
To Next Page