What to do if my EXIT Toys Swimming Pool has algae?
If algae is present in your EXIT Toys Swimming Pool, apply a shock treatment (super-chlorinator). Also, it is recommended to check the pH and adjust to an appropriate level, vacuum or lightly scrub the pool liner, and test the water often to maintain proper chlorine levels.
Why is the water in my EXIT Toys Swimming Pool colored?
Colored water in your EXIT Toys Swimming Pool can occur if chlorine is oxidizing minerals, especially with water from different sources. Adjust the pH to the recommended level. Also, run the filter until the water is clear and regularly clean the cartridge.
What to do if there are particles suspended in the water of my EXIT Toys Swimming Pool?
If you observe particles suspended in the water of your EXIT Toys Swimming Pool, it could be due to “Hard Water” caused by an elevated pH, so adjust the pH. Ensure a proper chlorine level. Clean or replace your filter. Also, spray off dirt with a high-pressure hose before entry.
How to fix a persistent low water level in my EXIT Toys Swimming Pool?
A persistent low water level in your EXIT Toys Swimming Pool may be due to several reasons: * A tear or hole in the pool liner: Locate the damage and repair it with the included patch kit. * A tear or hole in a filter pump hose: Repair or replace the hoses. * Hose clamps are too loose: Tighten all hose clamps. * Evaporation from high summer temperatures: Keep the pool covered when not in use.
Why is the water in my EXIT Toys Swimming Pool cool?
The water in your EXIT Toys Swimming Pool might be cool because the pool was set up in an excessively shady or tree-lined area. Relocate the pool to a more open location where it can get maximum exposure to sunlight during peak daylight hours. Also, heat might be escaping from the pool water, so keep your pool covered whenever it is not in use.
Ensure at least one responsible adult supervises children and non-swimmers.
Never permit diving or jumping into the pool; avoid raised surfaces.
Maintain accessible safety equipment and ensure adequate lighting.
Select a firm, flat area with no bumps and a slope not exceeding 3°.
Ensure the setup area is free of sticks, stones, sharp objects, and debris.
Avoid areas under power lines or trees and check for underground utility lines.
Account for all parts and check against the part reference list before assembly.
Install the drain valve cover, outer drain plug, and stoppers correctly.
Insert horizontal beams through the sleeves of the pool liner.
Attach foot pads and install T-joints to complete the frame structure.
Fill the pool carefully, ensuring it is level and avoiding overfilling.
Disconnect the filter pump and attach a hose for complete pool water drainage.
Ensure the pool liner is completely dry before folding for storage.
Store the pool and accessories in a cool, dry, and weatherproof indoor location.
Follow specific steps to fold the pool liner into a compact rectangle for storage.
Maintain water quality with consistent chemical treatment and safe handling.
Regularly test water quality and clean filter cartridges for optimal performance.
Utilize pool covers and ensure bather hygiene for water clarity and longevity.
Monitor water levels and pool hardware for proper maintenance and safety.
Address water discoloration and cloudiness due to minerals, chlorine, or hard water.
Resolve issues with debris in water and leaks causing a persistent low water level.
Treat algae growth and improve water temperature by ensuring proper chemical balance and location.
General| Brand | EXIT Toys |
|---|---|
| Model | 12FTX48IN |
| Category | Swimming Pool |
| Language | English |
To Next Page