Network Setup
Summit WM3000 Series Controller System Reference Guide100
Configuring the Virtual Interface
Use the Configuration screen to view and configure the virtual interface details.
1 Select Network > Controller Virtual Interface from the main tree menu.
2 Select the Configuration tab.
The following configuration details display in the table:
Name
Displays the name of the virtual interface.
VLAN ID
Displays the VLAN ID associated with the interface.
DHCP Enabled
Displays whether the DHCP client is enabled or not. A green check mark
defines the DHCP client as enabled for the interface. A red X means the
interface is disabled.
Primary IP Address
Displays the IP address for the virtual interface.
Primary Subnet Mask
Displays the subnet mask assigned for this interface.
Admin Status
Displays whether the virtual interface is operational and available to the
controller.
Oper Status
Displays whether the selected Controller Virtual Interface is currently (Up)
or not (Down) on the controller.
To Next Page
Loading...