Summit WM3000 Series Controller System Reference Guide 101
3 Select a record from the table and click the Edit button to modify the record. For more information,
see “Modifying a Virtual Interface” on page 103.
4 Select a record from the table and click the Delete button to remove the configuration from the list of
controller virtual interfaces.
5 Click the Add button to add a new configuration to the controller virtual interface. For more
information, see “Adding a Virtual Interface” on page 101.
6 Select an interface as click the Startup button to invoke the selected interface the next time the
controller is booted.
7 Select an interface as click the Shutdown button to disable the selected interface.
Adding a Virtual Interface
To add a new controller virtual interface:
1 Select Network > Controller Virtual Interface from the main tree menu.
2 Select the Configuration tab.
3 Click on the Add button.
Management
Interface
A green checkmark within this column defines this VLAN as currently
used by the controller. This designates the interface settings used for
global controller settings in case of conflicts. For example, if multiple
CVIs are configured with DHCP enabled on each, the controller could
have multiple domain names assigned from different DHCP servers.The
one assigned over the selected Management Interface would be the only
one used by the controller. This setting does not affect any of the
Management Access Interfaces configured using
“Configuring Access Control” on page 424.
To Next Page
Loading...