Network Setup
Summit WM3000 Series Controller System Reference Guide228
2 Click on OK button to save and commit the new configuration.
3 Click Cancel to disregard the changes and revert back to the previous configuration.
Viewing and Configuring Port Instance Details
Use the Port Instance tab to view and configure MST parameters per port per instance, including Port
Priority and Admin Internal Path Cost.
To view and configure the MSTP bridge instance:
1 Select Network > Multiple Spanning Tree from the main menu tree.
2 Select the PortInstance tab.
Port Path Cost
Port Path Cost Displays the path cost for the specified port index. The
default path cost depends on the speed of the interface.
Speed Default path cost
<=100000 bits/sec 200000000
<=1000000 bits/sec 20000000
<=10000000 bits/sec 2000000
<=100000000 bits/sec 200000
<=1000000000 bits/sec 20000
<=10000000000 bits/sec 2000
<=100000000000 bits/sec 200
<=1000000000000 bits/sec 20
>1000000000000 bits/sec 2
Admin Point-to-Point
status
Define the point-to-point status as ForceTrue or ForceFalse. ForceTrue
indicates this port should be treated as connected to a point-to-point link.
ForceFalse indicates this port should be treated as having a shared
connection. A port connected to a hub is on a shared link, while one
connected to a controller or workstation is a point-to-point link.
Port Enable
Select this checkbox to use this port for the forwarding of packets on the
controller.
Port Migration
The controller can interoperate with legacy 802.1d bridges running STP /
RSTP. If the port receives a legacy 802.1D configuration BPDU, it only
sends 802.1D BPDUs over its port from that point on. Enable this option
to restart detection of whether the port is connected to an MSTP capable
bridge or a legacy 802.1 bridge.
Admin Edge Port
Select the checkbox to define this port as an admin edge port.
To Next Page
Loading...