Summit WM3000 Series Controller System Reference Guide 295
8 If necessary, click the Stop Discovery button (enabled only during the discovery operation) to stop the
discovery operation.
Adding a New Discovery Profile
If the contents of an existing profile are no longer relevant to warrant modification using the Edit
function, then a new controller discovery profile should be created
To create a new controller discovery profile:
1 Select Services > Discovery from the main menu tree.
2 Click the Add button at the bottom of the screen.
IP Address
Lists the IP address of each discovered device.
Device Name
Displays the discovered device’s system assigned name.
Device Uptime
Lists the time each discovered device has been operating within the
controller managed network.
Device Location
Displays the devices detected location if the discovered device is capable
of sharing locationing information with the discovery profile.
Redundancy Group Id
If the discovered device is a member of a redundancy group, the group
name is listed.
Number of APs
Displays the number of APs managed by the controller capable of
detecting the listed device.
Software Version
Lists the software version currently running on each discovered device.
Product
Displays the name of the device discovered by the device search. If the
list of devices discovered is unsatisfactory, consider configuring a new
discovery policy and launching a new search.
Profile used for
Discovery
Displays the profile selected from within the Discovery Profiles tab and
used with the Start Discovery function to discover devices within the
controller managed network. If the group of devices discovered and
displayed within the Recently Found Devices tab does not represent the
device demographic needed, consider going back to the Discovery Profiles
tab and selected a different profile for the controller discovery process.
To Next Page
Loading...