Controller Services
Summit WM3000 Series Controller System Reference Guide296
Define the following parameters for the new controller discovery profile:
3 Refer to the Status field for an update of the edit process.
The Status is the current state of the requests made from the applet. Requests are any “SET/GET”
operation from the applet. The Status field displays error messages if something goes wrong in the
transaction between the applet and the controller.
4 Click OK to save the changes to the running configuration and close the dialog.
5 Click Cancel to close the dialog without committing updates to the running configuration.
Viewing Discovered Controllers
Refer to the Recently Found Devices tab to view a table of devices found by the discovery process. Each
discovered device compatible with the locating controller is displayed in a shaded color to distinguish it
from non-compatible devices. The controller Web UI enables users display the Web UI of the discovered
device in a separate browser window.
To view the devices located by the controller:
1 Select Services > Discovery from the main menu tree.
2 Select the Recently Found Devices tab.
Profile Name
Define a user-assigned name used to title the profile. The profile name
should associate the profile with the group of devices or area where the
discovered devices should be located.
Start IP Address
Enter the starting numeric (non DNS) IP address from where the search
for available network devices is conducted.
End IP Address
Enter the ending numeric (non DNS) IP address from where the search
for available network devices is conducted
SNMP Version
Use the drop-down menu to define the SNMP version (either v2 or v3)
used for discovering available network devices.
To Next Page
Loading...