Controller Services
Summit WM3000 Series Controller System Reference Guide300
1 Select Services > RTLS from the main menu tree.
2 .Select the Site tab.
3 Enter a Name and optionally a Description for the site:.
4 When mapping a site for locationing, an origin point must be selected in one of the corners of the
site. That origin will become the upper left corner of the site map with coordinates of 0,0. The length
and width of the site is then mapped out on the X and Y axis (with length being X and width being
Y). Those length and width along with the height are entered into the field below.
5 Define the Dimensions used to define the site size:
Name
Enter a name for the site where locationing is deployed. This is for
identification purposes only.
Description
Provide a description of the site where locationing is deployed. This is an
optional field.
Length
Enter the length of the site. This is the X
axis of your site map based on
the origin point of 0,0. The size is either in feet or meters depending on
which unit of measure is selected below. The valid range for length is 1-
3000m or 1-9000ft.
Width
Enter the width of the site. This is the Y axis of your site map based on
the origin point of 0,0. The size is either in feet or meters depending on
which unit of measure is selected below. The valid range for width is 1-
3000m or 1-9000ft.
To Next Page
Loading...