Summit WM3000 Series Controller System Reference Guide 301
6 The AP Information section displays the following information about APs:
7 Click the Apply button to save the changes made within this screen. Clicking Apply overwrites the
previous configuration.
8 Click the Revert button to disregard any changes made within this screen and revert back to the last
saved configuration.
Adding AP Location Information
To add AP Location information for your site
1 Select Services > RTLS from the main menu tree.
2 Select the Site tab.
3 Click the Add button
Height
Enter the height of the site. The size is either in feet or meters
depending on which unit of measure is selected below. The acceptable
range for height is 0-60m or 0-180ft. Height is an optional parameter
and is not taken into account by the locationing algorithm.
Unit
Use the drop-down menu to select the unit of measure used for
dimensions. The options are feet or meters.
AP MAC
Lists the MAC Addresses of all APs which have been configured for RTLS.
Location:
X Coordinate
Displays the value of the X Coordinate for each AP. The X coordinate is
relative to the origin point of 0,0 in the upper left corner of the site map.
This value is user configured and not detected by the controller. For
information on how to configure AP location information, see “Adding AP
Location Information” on page 301.
Location:
Y Coordinate
Displays the value of the Y Coordinate for each AP. The Y coordinate is
relative to the origin point of 0,0 in the upper left corner of the site map.
This value is user configured and not detected by the controller. For
information on how to configure AP location information, see “Adding AP
Location Information” on page 301.
Location:
Z Coordinate
Displays the value of the Z Coordinate for each AP. The Z coordinate is
the height of the AP relative to the lowest point of the site. This value is
user configured and not detected by the controller. For information on
how to configure AP location information, see “Adding AP Location
Information” on page 301.
Status
Displays the status value for each AP.
Controller IP
Displays the IP address of controller associated with each AP configured
for RTLS.
11a Radio
Displays the Index, MAC Address, Power and Channel information for the
802.11a radio on each AP.
11bg Radio
Displays the Index, MAC Address, Power and Channel information for the
802.11bg radio on each AP.
To Next Page
Loading...