Extreme Networks Summit WM3000 Series - Page 311

Summit WM3000 Series Controller System Reference Guide 311
AP detection is primarily conducted by the approved APs and may be assisted by certain Motorola
MUs which are supported by Extreme Networks WM3000 series WLAN controller. The Access Point
Detection screen consists of the following tabs:
● Enabling and Configuring AP Detection
● Approved APs
● Unapproved APs (Reported by APs)
● Unapproved APs (Reported by MUs)
Enabling and Configuring AP Detection
Use the Configuration screen to allow the controller to detect potentially hostile Access Points, set the
number of detected APs allowed and define the timeout and threshold values used for detection. The
controller can enable both Access Points and MUs to scan and detect Access Points within the controller
managed network. Continually re-validating the credentials of associated devices reduces the possibility
of an Access Point hacking into the controller managed network.
To configure AP Detection:
1 Select Security > Access Point Detection from the main menu.
2 Select the Configuration tab.