Controller Security
Summit WM3000 Series Controller System Reference Guide312
3 Enable AP assisted scanning and timeout intervals as required.
4 Refer to the MU Assisted Scan field to enable associated MUs to assist in the detection of Access
Points.
Enable
Select the
Enable
checkbox to enable associated Access Points to detect
potentially hostile Access Points. Once detected, the Access Points can
be added to a list of APs either approved or denied from interoperating
within the controller managed network.
Approved AP timeout
Define a value (in seconds) the controller uses to timeout (previously
approved) Access Points that have not communicated with the controller.
The range is from 1-65535 seconds, with a default of 300 seconds. This
value is helpful for continually re-validating Access Points that
interoperate within the controller managed network.
Unapproved AP
timeout
Define a value (in seconds) the controller uses to remove Access Points
that have not communicated with the controller. The range is from 1-
65535 seconds, with a default of 300 seconds.
To Next Page
Loading...