Extreme Networks Summit WM3000 Series - Page 37

Summit WM3000 Series Controller System Reference Guide 37
To define basic controller settings using the controller’s GUI:
1 Select Controller from the main menu tree.
2 Click the Configuration tab.
3 Refer the System field to define the following basic controller settings:
System Name Displays the designated system name. Provide a system name serving as
a reminder of the user base the controller supports (engineering, retail,
etc.).
Location The
Location parameter serves as a reminder of where the controller can
be found. Define the System Name as a specific identifier of the
controller’s location. Use the System Name and Location parameters
together to optionally define the controller name by the radio coverage
type it supports and physical location. For example, “second floor
engineering.”
Contact Displays a
Contact value for system administration and troubleshooting.
This name should be the network administrator responsible for controller
operations.
Uptime Displays the current operational time for the device name defined within
the System Name field. Uptime is the cumulative time since the
controller was last rebooted or lost power.
Firmware Displays the current firmware version running on the controller. This
version should be periodically compared to the most recent version
available on the Extreme Networks Web site, as versions with increased
functionality are periodically released.
AP Licenses Displays the number of Access Point licenses currently available for the
controller. This value represents the maximum number of Access Points
the controller is licensed to adopt.