Summit WM3000 Series Controller System Reference Guide 435
6 Highlight a specific trap and click the Enable Trap button to enable this specific trap as an active
SNMP trap.
The items previously disabled (with an "X" to the left) now display with a check to the left of it.
7 Highlight a specific trap and click the Disable Trap button to disable the item as an active SNMP trap.
The items previously enabled (with a check to the left) now display with an "X" to the left of it.
8 Highlight a sub-menu header (such as Redundancy or Update Server) and click the Enable Trap for
sub-items button to enable the item as an active SNMP trap.
Those sub-items previously disabled (with an "X" to the left) now display with a check to the left of
them. Once the Apply button is clicked, the selected items are now active SNMP traps on the system.
9 Highlight a sub-menu header (such as Redundancy or SNMP) and click the Disable Trap for sub-items
sub-items button to disable the item as an active SNMP trap.
Those sub-items previously enabled (with a check to the left) now display with an "X" to the left of
them.
10 Click Apply to save the trap configurations enabled using the Enable or Enable all sub-items options.
11 Click Revert to discard any updates and revert back to its last saved configuration.
Configuring E-mail Notifications
To enable e-mail notification:
1 Select Management Access > SNMP Trap Configuration from the main menu tree.
2 Click the Email Configuration button to launch a dialogue where you can configure outgoing E-mail
servers and addresses for alerts.
To Next Page
Loading...