Controller Management
Summit WM3000 Series Controller System Reference Guide436
3 Check the Enable SMTP box to enable the outgoing mail server on the controller. In order to use E-
mail notification on the controller, this box must be checked.
Configure the SMTP mail server properties as follows:
4 Configure the mail-to section of the page as follows:
5 Click OK to save and add the changes to the running configuration and close the dialog.
6 Click Cancel to close the dialog without committing updates to the running configuration.
Configuring Trap Thresholds
Use the Wireless Statistics Thresholds screen to modify existing threshold conditions values for individual
trap descriptions. Refer to the greater than, less than and worse than conditions to interpret how the
values should be defined. Additionally, the Unit of threshold Values increment should be referenced to
interpret the unit of measurement used.
To configure SNMP trap threshold values:
1 Select Management Access > SNMP Trap Configuration from the main menu tree.
2 Click the Wireless Statistics Thresholds tab.
Name
Enter the hostname of your outgoing SMTP mail server. This is the server
that is used to deliver outgoing mail.
Port
Specify the port number used by your outgoing SMTP server. In many
cases this is port 25.
User Name
Enter the username for the user which will be sending outgoing mail
through the SMTP server.
Password
Enter the password associated with the above username.
Enable
Authentication
Check the Enable Authentication box to enable support for SMTP
Authentication which is required for certain outgoing SMTP servers.
To Address(es)
Specify an e-mail address or addresses that notifications will be sent to.
To add an e-mail address to the list, enter the email address in the To
Address(es) field and click the Add button. There is a maximum of 4 e-
mail addresses allowed on the list.
Add
Click the Add button to add an e-mail address that is in the To
Address(es) field to the list below.
Remove
Select an e-mail address from the list and click the Remove button to
delete that address from the list.
From Address
Enter an e-mail address serving as the From address for the notifications
sent by the controller.
Subject Prefix
Enter a short subject line that prepends the subject line in each outgoing
notification e-mail.
To Next Page
Loading...