Controller Management
Summit WM3000 Series Controller System Reference Guide444
3 Enter the login name for the user in the Username field. Ensure this name is practical and identifiable
to the user.
4 Enter the authentication password for the new user in the Password field and reconfirm the same
again in the Confirm Password field.
5 Select the role you want to assign to the new user from the options provided in the Associated Roles
panel. Select one or more of the following options:
Monitor
Select
Monitor
to assign regular user permissions without any
administrative rights. The Monitor option provides
read-only
permissions.
Help Desk Manager
Assign this role to someone who typically troubleshoots and debugs
problems reported by the customer. The Help Desk Manager typically runs
troubleshooting utilities (like a sniffer), executes service commands,
views/retrieves logs and reboots the controller.
Network
Administrator
The
Network Administrator
has privileges to configure all wired and
wireless parameters like IP config, VLANs, Layer 2/Layer 3 security,
WLANs, radios and hotspot.
System Administrator
Select
System Administrator
to allow the user to configure general
settings like NTP, boot parameters, licenses, perform image upgrade, auto
install, manager redundancy/clustering and control access.
Web User
Administrator
Assign
Web User Administrator
privileges to add users for Web
authentication (hotspot).
To Next Page
Loading...