Extreme Networks Summit WM3000 Series - Editing the Port Configuration

Summit WM3000 Series Controller System Reference Guide 55
Editing the Port Configuration
To modify the port configuration:
1 Select a port from the table displayed within the Configuration screen.
2 Click the Edit button.
A Port Change Warning screen displays, stating any change to the port setting could disrupt access to
the controller. Communication errors may occur even if modifications made are successful.
3 Click the OK button to continue.
Optionally, select the Don’t show this message again for the rest of the session checkbox to disable the
pop-up.
4 Use the Edit screen to modify the following port configurations for the selected port.