Summit WM3000 Series Controller System Reference Guide 57
Viewing the Ports Runtime Status
The Runtime tab displays read-only runtime configuration for uplink and downlink ports.
To view the runtime configuration details of the uplink and downlink ports:
1 Select Controller > Port from the main menu tree.
2 Select the Runtime tab to display the following read-only information:
Reviewing Port Statistics
The Statistics tab displays read-only statistics for ethernet ports. Use this information to assess if
configuration changes are required to improve network performance.
To view the runtime configuration details of the controller ports:
1 Select Controller > Port from the main menu tree.
2 Select the Statistics tab.
Name
Displays the port’s current name.
MAC Address
Displays the port’s MAC Address. This value is read-only, set at the
factory and cannot be modified.
Oper Status
Displays the link status of the port. The port status can be either Up or
Down.
Speed
Displays the current speed of the data transmitted and received over the
port.
Duplex
Displays the port as either
half
duplex
,
full
duplex
or
Unknown.
MTU
Displays the
maximum transmission unit
(MTU) setting configured on the
port. The MTU value represents the largest packet size that can be sent
over a link. 10/100 Ethernet ports have a maximum MTU setting of
1500.
To Next Page
Loading...