Summit WM3000 Series Controller System Reference Guide 65
1 Select Controller > Configurations from the main menu tree.
The following information is displayed in tabular format. Configuration files (with the exception of
startup-config and running-config) can be edited, viewed in detail or deleted.
2 To view the contents of a config file in detail, select a config file by selecting a row from the table
and click the View button. For more information, see “Viewing the Detailed Contents of a Config
File” on page 67.
3 Select a configuration (other than the start-up-config or running config) and click the Install button to
install the file on the controller and replace the existing startup-config file.
If a file (for example, sample-config) is selected, a message displays stating, “When sample-config is
installed, it will replace start-up config. Are you sure you want to install sample-config.” Click Yes to
continue.
Name
Displays the name of each existing configuration file.
Size (Bytes)
Displays the size (in bytes) of each available configuration file.
Created
Displays the date and time each configuration file was created. Use this
information as a baseline for troubleshooting problems by comparing
event log data with configuration file creation data.
Modified
Displays the date and time each configuration file was last modified.
Compare this column against the Created column to discern which files
were modified and make informed decisions whether existing files should
be further modified or deleted.
Path
Displays the path (location) to the configuration file.
To Next Page
Loading...