Controller Information
Summit WM3000 Series Controller System Reference Guide66
Selecting either the startup-config or running-config does not enable the Edit button. A different configuration
must be available to enable the Edit function for the purposes of replacing the existing startup-config.
4 To permanently remove a file from the list of configurations available to the controller, select a
configuration file from the table and click the Delete button.
If startup-config is deleted, a prompt displays stating the default controller startup-config will
automatically take its place. The controller running-config cannot be deleted.
5 To restore the system’s default configuration and revert back to factory default, click the Restore
Defaults button.
After setting the controller to revert to factory default settings, the system must be rebooted before the default
settings take effect. When this occurs, the controller IP address may change.
6 Click the Transfer Files button to move a target configuration file to a secure location for later use. For
more information, see “Transferring a Config File” on page 68.
To Next Page
Loading...