Summit WM3000 Series Controller System Reference Guide 85
5 Network Setup
This chapter describes the Network Setup menu information used to configure the controller. This
chapter consists of the following controller Network configuration activities:
● Displaying the Network Interface on page 85
● Viewing Network IP Information on page 87
● Viewing and Configuring Layer 2 Virtual LANs on page 94
● Configuring Controller Virtual Interfaces on page 99
● Viewing and Configuring Controller WLANs on page 109
● Viewing Associated MU Details on page 166
● Viewing Access Point Information on page 176
● Viewing Access Point Adoption Defaults on page 202
● Viewing Adopted Access Points on page 212
● Multiple Spanning Tree on page 217
● Configuring IGMP Snooping on page 230
Displaying the Network Interface
The main Network interface displays a high-level overview of the configuration (default or otherwise) as
defined within the Network main menu. Use the information to determine if items require additional
configuration using the sub-menu items under the main Network menu item.
When the controller’s configuration is successfully updated (using the Web UI), the affected screen is closed without
informing the user their change was successful. However, if an error were to occur, the error displays within the
affected screen’s Status field and the screen remains displayed. In the case of file transfer operations, the transfer
screen remains open during the transfer operation and remains open upon completion (with status displayed within
the Status field).
To view the controller’s Network configuration:
To Next Page
Loading...