Extron electronics DTP T UWP 4K 232 D - Page 34

Extron DTP T UWP 4K D Series • Reference Information 27
5. On the next screen that appears, enter the requested user information, then click the
Download button.
6. Follow the instructions on the rest of the download screens to save the executable firmware
file to the computer. Note the folder to which the file was saved.
7. In Windows Explorer or another file browser, locate the downloaded executable file and
double-click it to run it.
8. Follow the instructions on the Installation Wizard screens to install the new firmware
on the computer. A Release Notes file and a set of instructions for updating the firmware are
also loaded.
Loading firmware to the transmitter
To load a new version of firmware to the transmitter using PCS, follow these instructions.
1. If not already installed, download and install the PCS executable
installer file to the computer (see Downloading and Installing PCS on page 20).
2. If necessary, download the latest version of firmware for the desired product (see
Downloading Device Firmware on the previous page).
3. Connect the transmitter to the computer using the front panel USB connector
(
D
on page6).
4. Open PCS. If there is no desktop icon, open the program from the Start menu by selecting:
Start > All Programs > Extron Electronics > Extron Product
Configuration Software> Product Configuration Software
The Device Discovery screen opens with the connected transmitter shown in the
device list.