EYELA A-1000S - User Manual

Questions and Answers

J
jason69Aug 6, 2025
What to do if EYELA A-1000S motor doesn't work?
- K
  Kenneth Valentine MDAug 6, 2025
  If the motor of your EYELA Medical Equipment isn't working even when the power switch is on, here are a few things to check: - Make sure the mains connector is properly plugged into the outlet. If it's loose, turn off the power and plug it in tightly. - Verify that power is being supplied by checking and turning on the breaker of the distribution board if necessary. - Inspect the fuse and replace it if it has blown. If the issue persists after replacing the fuse, stop using the equipment immediately and seek assistance from your local dealer or customer service center. - The thermal protector may be activated. Try lowering the ambient temperature or the water temperature of the bath.
F
foleylauraAug 16, 2025
How to fix poor vacuum degree in EYELA Medical Equipment?
- J
  jenniferhaysAug 16, 2025
  If you're experiencing a poor vacuum degree with your EYELA Medical Equipment, consider these potential causes and solutions: - If solvent has dissolved into the water, replace the water in the aspirator bath, or prevent solvent from mixing into the water. - If the water temperature in the bath is too high, use the unit with Overflow, or place a cooling coil into the bath and connect it to a cooling water circulating device to lower the water temperature. - If the metal aspirator is clogged, remove the obstructing dirt. - Check the backflow prevention valve for clogs.
B
brandismithAug 27, 2025
Why is there poor air volume displacement in EYELA A-1000S?
- P
  parsonskevinAug 27, 2025
  Poor air volume displacement in your EYELA Medical Equipment may be due to several factors: - Corrosion or wear of the metal aspirator. If this is the case, replace the metal aspirator. - Dirt clogged in the pump casing. Remove any dirt found in the casing. - Metal aspirator clogged with foreign substance. Remove the dirt. - If the pump part is cracked, stop operation immediately and contact your local dealer or customer service center. - Check the backflow prevention valve for clogs. - Water leaks from casing packing. - F cheese of pump part is damaged because of organic solvent.