EZ Answer
Number of rings to pick up:
When the PBX routes an incoming call to the unit, it may be
programmed to answer the call on either the first ring or
anywhere up to the ninth ring.
Enter 202 n where n = 1 to 9 rings
If 0 or * is entered, the unit will prompt the message “This
entry is invalid”.
Default value = 1
Length of entry = fixed 1 digit
Program # 242:
To listen to the currently programmed value for the Number of
rings to pick up -
You will hear:
“ Two Four Two (0.6 sec silence) One”
Program # 203:
Message Delay period -
This value determines the delay period between the unit going
off hook to the start of the message playing.
Enter 203 n where n = 0 to 9 n x 0.2 sec gives the total
delay period.
If * is entered, the unit will prompt the message “This entry is
27
To Next Page
Loading...