Ez-Boom 2010 Quick Reference Card

EZ-Boom
™
2010 Automated Application
Control System Quick Reference Card
www.EZ-Boom.com
INTRODUCTION
This figure shows the front panel of the EZ-Boom™ 2010 automated application control system.
CONNECTING
This figure shows how to connect the EZ-Boom controller to the other system components.
1. On the EZ-Steer® system power cable (P/N 52763), disconnect the female DE9 connector
(“EZ-STEER CONTROLLER”) from the EZ-Steer controller (if fitted).
2. On the EZ-Boom “Y” cable (P/N 58377):
a. Connect the male DE9 connector marked “TO POWER” to the female DE9 connector marked
“EZ-STEER CONTROLLER” on the EZ-Steer power cable (P/N 52763).
b. Connect the female DE9 connector marked “TO SCM” to:
• the EZ-Steer controller (if an EZ-Steer system is installed)
• the CAN terminating connector (if an EZ-Steer system is not installed)
3. Connect the Deutsch connector (“TO EZ-BOOM”) to the socket on the back of the EZ-Boom controller.
Boom section
Rate Adjustment (Inc/Dec) switch
switches
Rate switch
Status indicator
Master switch
58378R REV 1 DCA 0615
EZ-Boom controller
EZ-Steer controller
EZ-Boom “Y” cable
Power
EZ-Guide Plus
lightbar
“TO SCM”
“TO EZ-BOOM”
“TO POWER”
“EZ-STEER CONTROLLER”
CAN terminator
(P/N 58377)
(P/N 58378)
EZ-Steer cable
(P/N 52763)
OR

Ez-Boom 2010 Specifications

General

Brand	Ez-Boom
Model	2010
Category	Control Systems
Language	English